Plug it in
Setting up the Doppler is really easy (it is an alarm clock, after all). Pull the Doppler out of the box. Then, pull the flap up to expose the white box which contains the power brick and power cable. Plug the figure 8 connector of the power cable into the power brick (note that it will not go in all the way). Plug the pronged end of the power cable into a power outlet. Then, plug the round end (image above) into the back of the Doppler (make sure the plug is properly oriented — the flat side should be facing up). On boot, the Doppler will turn on its lights in the bootup animation.
The Doppler was designed for your nightstand, but it will work wherever you want to use it! A channel at the bottom of the Doppler allows you to route your charging cables underneath.

Do the USB ports have fast charging for an iPhone through the USB-C to lightning cable?
Hi Gordon, all USB ports will charge fast. They are all at least 15 watts.
How do I edit the dopplers time?
Hi there, you’ll want to go to clock setup mode by holding down the clock button and then pressing plus or minus to get to the proper time. Or connect to wifi. More info here: https://manual.sandmandoppler.com/basic-use/